Deal with it in time if there is an abnormality in the waste heat boiler

　　How to install the waste heat boiler, see the following steps:

　　It should be noted that the electric heating heat conduction oil furnace with electric heating power ≥ 100kKW belongs to the heat carrier boiler, and the installation requires relevant personnel.

　　2. Installation of the main engine: The electric heating heat conduction oil furnace should be horizontally and stably placed in a position that is convenient for viewing, operation and maintenance.

　　3. Selection of heat transfer oil and oil filling: After the entire heating system is installed and inspected, the system is filled with oil. The heat transfer oil is filled through the expansion tank's oil filling port. When filling the oil, open the valves in the system (except the oil drain valve), and then pass The expansion tank slowly injects the heat transfer oil into the system.

　　Fourth, its dehydration and exhaust: During the dehydration and exhaust process, a large amount of gas may rush into the expansion tank, causing the heat transfer oil in the tank to overflow. Before operation, place an oil spill container under the oil spill pipe. When dewatering and exhausting, there should be staff guards on the spot, and if any abnormalities are found, they should be dealt with in time.

　　5. Temperature control of the heat-conducting oil heater system Attention! The heat fastening of the heating body wiring fasteners should be performed in the power-off state. Observe and adjust the relevant parameters of the temperature control instrument, and implement automatic temperature control operation until stable control.