Pharmaceuticals Industry
Pharmaceutical Industries need a lot of steam, mainly used in the following sections: 1. High temperature sterilization and disinfection of raw materials and medical instruments; 2. Decocting and drying Chinese medicinal materials; 3. Decocting and drying Chinese medicinal materials; 4. In terms of medical and health care, it mainly conducts disinfection of medical supplies (hospital gowns, bed sheets, etc.), kitchen steaming rice and ward heating, etc. Steam and hot water will be used.
However, with the implementation of the policy of energy conservation and emission reduction, reducing energy consumption as much as possible on the premise of meeting the production requirements has become a problem for many pharmaceutical enterprises. Therefore, more and more gas-fired boilers are being used.
Boiler Model Selection used for Pharmaceuticals Industry
The pharmaceutical industry has a high requirement for environmental sanitation and steam quality. The energy consumption is very large. When select boilers, both the discharge coefficient standards and steam quality have to be considered. Xinli gas-fired boilers change the combustion mode of traditional boilers, with ultra-low emission and nitrogen oxide emission meeting and exceeding the emission standards of national environmental protection departments.
Boiler Model Recommendation
How to Choose the
Suitable Boiler for
Pharmaceuticals Industry
Determine Boiler Medium
According to the utility of boiler, it could be steam boiler or hot water boiler.
Determine Boiler Fuel
Boilers are divided into fuel oil gas boilers, coal-fired boilers, biomass boilers, electric boilers. Gas boiler is convenient to control the temperature. However, it is necessary to consider whether it is convenient to install the gas pipeline. If it is not convenient, it is necessary to consider the use of oil-fired or electric boilers. However, oil-fired boilers need to consider transportation and storage issues, and electric boilers need to install special electrical equipment.
Determine Boiler Capacity
he capacity of the boiler shall be calculated according to the heat load curve or the heat balance system diagram, and the heat loss into the pipeline, the heat used in the boiler room and the available waste heat.
Determine Boiler Efficiency
Boiler should have high efficiency. The boiler output, the number of sets and other performance can adapt to the demand of heat load change, in order to facilitate economic management. If the use of one boiler operating at full load can meet the demand for steam, it is not appropriate to use two boilers operating under lower load. However, from the perspective of safety production, it is necessary to consider whether a single boiler in operation can be started quickly in a short time due to failure, so as to meet heating requirements without affecting production.
Capacity and Model
When boiler with different capacity and different types is selected, the boiler with the same capacity and combustion equipment should be selected. If not, try to construct the responsible line of equipment layout and maintenance management. The same model with different capacities or different models with same capacity could be choosed.
Cooperative Partner
Contact Us
Resolve Your Problems within One Minute
Address：No.11 Minhe Road, Private Industrial Park, Development Zone, Kaifeng City
Inquiry
If you have any questions about our company and products, please contact us immediately. Any inquiries and Suggestions would be appreciated.
We will keep your information confidential.
Kaifeng Xinli Boiler Equipment Co., Ltd.
Address: No.11 Minhe Road, Private Industrial Park, Development Zone, Kaifeng City
Email: [email protected]
WhatsApp: +0086-13803825084
© Kaifeng Xinli Boiler Equipment Co., Ltd. All rights reserved.